Kodak 500, 630, 700 service manual Disassembly

NovaJet 500/630/700 Series Service Manual

6.Remove the screws that secure the Left Sideplate Assembly to the Platen. Remove the Left Sideplate Assembly and the left Foam Block. See Figure 5-24.

NOTE

The 42 inch model has one Vacuum Fan and Exhaust assembly while the 60 inch has two sets of Vacuum Fans and Exhausts.

7.Using a #1 Phillips screwdriver, remove the four screws on the bottom of the Platen which holds the Fan Exhaust(s) in place.

8.On the NovaJet 750, remove the Platen Plug from under the Platen.

9.On the NovaJet 750, remove the black flat-head screws from the top of the Platen that holds the Center Support in place. Remove the Center Support through the Platen Plug hole.

10.While holding the Vacuum Fan through the hole left when the Exhaust assembly was removed, remove the 3 screws on the bottom of the Platen that holds the Vacuum Fan in place using a #2 Phillips screwdriver. Do not allow the screws to come out at an angle.

11.Using a #1 Phillips screwdriver, remove the black flat-head screws from the top of the Platen that holds the left and right Drive Shaft Supports in place.

ASSEMBLY/

DISASSEMBLY

It may be necessary to loosen (do not remove) the screws that secure the Y-Arm Assembly to the Platen so that the Lower Drive Roller Assembly clears the ends of the screws that protrude inside of the Platen when remov- ing the Lower Drive Roller Assembly.

Assembly\Disassembly 5-45