NovaJet 500/630/700 Series Service Manual
Figure 5-10. Slacken Carriage Belt.
6.Remove the Right Sideplate to gain access to the Servo Motor by unscrewing the four screws securing it to the Platen.
7.Depress the back of the Frame Tensioner (see Figure
8.Move the Carriage Belt to the left so it is out of the way of the Servo Motor pulley.
9.Move the Carriage Assembly to the left end of the Slide Shaft.
10.Lift up gently and hold the right end of the Trailing Cable.
11.Using a #2 Phillips screwdriver, remove the back screw on the Servo Motor. The screwdriver will be at a slight angle.
Be careful not to strip the head of the screw or to cause damage to the Encoder Strip.
12. Lower the Trailing Cable back into place.
