NovaJet 500/630/700 Series Service Manual
Power Feed and Take-Up Motor Winding Resistance Check
Figure 3-9. Power Feed and Take-Up Motor.
1.Remove the feed and/or
2.Using Phillips screwdriver, remove the four screws that secure the cradle idler from the right leg.
3.Ease the cradle idler off of the leg enough to disconnect the motor wires from the leg harness.
4.Using a standard ohmmeter or multimeter, measure between the + and - connections on the motor. While manually rotating the servo motor, monitor the readings on the meter. The acceptable range is
5.If the measurement is found to be unsatisfactory, replace the motor.
6.Perform the same procedure on the remaining motor.
