Kodak 630, 500, 700 service manual Assembly\Disassembly

NovaJet 500/630/700 Series Service Manual

11.Reinsert the Service Station.

12.Reinstall the Right Sideplate using a #2 Phillips screwdriver. Ensure that all cables from inside the Platen are exiting out of the large hole in the Sideplate.

13.Reinstall the Power Supply Bracket using four screws and a #2 Phillips screwdriver.

14.Perform steps 5 through 14 of the procedures to reconnect the MPCB.

15.Reinstall the left Foam Block.

16.Reinstall the Left Sideplate Assembly using a #2 Phillips screwdriver.

17.Perform steps 1 through 4 of the Install the Ink Delivery System procedures to reinstall the Ink Delivery System.

18.Perform the Install Left, Top, and Right Covers procedures to install the Left, Top, and Right Covers.

Remove the Media Take-Up and Feed Sensor Brackets and Sensors

NOTE

The sensors for the media Take-Up and Feed Assembly are identical, but the brackets that they mount to have distinct differences. The top bracket has an additional extended arm attached to help in directing the media from blocking the sensor’s beam path. Ensure that the bracket is being replaced with the correct bracket.

1.Remove all media and media rollers from the printer.

2.Disconnect the sensor leads from the printers leg assembly by squeezing the sides of the connector to release the quick disconnect latches.

3.With a pair of wire cutters, cut the wire tie wraps (see Figure 5-28) that is securing the sensor leads to the sensor bracket.

5-50 Assembly\Disassembly