Kodak 700, 630, 500 service manual Strain Relief Removal/Installation

NovaJet 500/630/700 Series Service Manual

Figure 5-14. Strain Relief Removal/Installation.

5.Remove the Trailing Cable and Strain Relief from the Carriage Assembly by releasing the latch on the left lower side of the Strain Relief and lifting it off of the Carriage Assembly. See Figure 5-14.

6.Compress the back of the Frame Tensioner and use the end of a screwdriver to remove the Carriage Belt from the Servo Motor pulley. See Figure 5-10.

7.Remove the Compression Spring from the Frame Tensioner and set it aside.

8.Push the Carriage Belt through the Frame Tensioner enough to remove the Idler Pulley Assembly from the Frame Tensioner, and then set aside the Idler Pulley Assembly and the Frame Tensioner. See Figure 5-15.

ASSEMBLY/ DISASSEMBLY

Assembly\Disassembly 5-25