Kodak 630, 500, 700 service manual Y-Arm Installation/Removal

NovaJet 500/630/700 Series Service Manual

4.Perform steps 3 and 4 of the Remove the Trailing Cable Assembly procedures to remove the Trailing Cable Assembly.

5.Perform steps 5 and 6 of the Remove the Stabilizer Bracket and Encoder Strip procedures to remove the Stabilizer Bracket Assembly.

6.Disconnect the Load Sensor connector at the J4 location on the MPCB. Grasp the Load Sensor connector with the thumb and forefinger and pull straight out.

7.Remove the seven screws that secures the Y-Arm Assembly to the Platen. See Figure 5-24.

ASSEMBLY/

DISASSEMBLY

Figure 5-24. Y-Arm Installation/Removal.

8.The pinch rollers are held on by a small C clamp located on the back of the Y-Arm Assembly. See Figure 5-25. While holding the pinch roller, remove the C clamp and move the pinch roller towards the front of the Y-Arm Assembly until it clears the back of the Y-Arm Bracket.

Assembly\Disassembly 5-41