Kodak 500, 630, 700 service manual Pinch Roller

NovaJet 500/630/700 Series Service Manual

Figure 5-25. Pinch Roller.

9.Spin the back of the pinch roller to either side and remove the back spring.

10.Carefully tilt the back of the pinch roller upwards. This brings the front of the pinch roller down, away from the Slide Shaft. Carefully remove the spring that is going into the Slide Shaft from the top of the pinch roller.

11.Remove the pinch roller.

12.From the bottom of the Y-Arm Assembly, remove the four screws that secure the Slide Shaft and its two supports from the Y-Arm Assembly.

13.Using a #1 Phillips screwdriver, remove the two screws that secure the Auto-Load Sensor to the Y-Arm. Remove the Auto-Load Sensor wires from the four wire clamps on the back part of the Y-Arm Bracket.

5-42 Assembly\Disassembly