NovaJet 500/630/700 Series Service Manual
The Slide Shaft is set to 1.418” (36cm) from the top of the Slide Shaft to the Platen surface for the NovaJet 500, 630 and 700 series printers. The normal operating range for the height of the Slide Shaft is between 1.390” (35.3cm) to 1.440” (36.6cm).
The NovaJet 505 Slide Shaft is set to 1.478” (37.5cm) from the top of the Slide Shaft to the Platen surface. The normal operating range for this height of the Slide Shaft is between 1.471” (37.4cm) to 1.483” (37.4cm).
You will need the following:
·Height Gauge Kit Assembly
·1/4" open and box end wrench (.110” thick)
Height Gauge (Alignment) Kit Contents are: Dial Gauge Micrometer
Modified Novajet Cartridge for newer products Modified Novajet 4/Pro/Pro 50 Cartridge - Not Used
Platen/Carriage Shaft Mounting Block |
|
Calibration Jo Block (1.434”) | - Not used |
Plastic Gauge Card (0.011”) | - Not used |
There are two basic measurements that are to be made using this kit (ensure power is off prior to performing these procedures):
1.Slide Shaft Profile Adjustment
2.Carriage (Cartridge) Head Height Setting
1.Connect the dial gauge micrometer to the Shaft mounting block as shown in Figure
ZERO 
GAUGE
SHAFT
MOUNTING
TIGHTEN SETBLOCK
SCREW (NOT
SHOWN)
Figure 3-11. Dial Gauge Micrometer Assembly.
MAINTENANCE
Maintenance
