Paper and Encoder Sensor Removal | Kodak 630, 500, 700 guide

NovaJet 500/630/700 Series Service Manual

TO REMOVE PAPER

SENSOR BOARD, GRASP

HERE AND PULL UP

PUSH DOWN ON

CLIP, PUSH DOWN

ON ENCODER,

THEN PULL OUT

THIS PIECE OF PLASTIC (ONE ON EACH SIDE) MUST CLEAR THE RIDGES ON THE UNDERSIDE OF THE HOLDER

Figure 5-18. Paper and Encoder Sensor Removal.

2.To remove the Paper Sensor:

a.Unlock the connector at J3 and remove the flex cable.

b.Turn the Carriage Assembly over and hold it while firmly grasping the Paper Sensor between thumb and index finger. See Figure 5-18.

c.Pull straight up on the Paper Sensor and remove it from the Carriage Assembly.

3.To remove the Encoder Sensor:

a.Unlock the connector at J2 and remove the flex cable.

b.Turn the Carriage Assembly over and lay it with the top side facing down.