Delta 32-350 Assembly, Assembling Stand Mounting Feet, Assembling Machine to Stand

ASSEMBLY

ASSEMBLING STAND

AND MOUNTING FEET

1.Assemble front panel (A) Fig. 2, and rear panel (B) to side panels (C) with eight 5/8 inch-long screws, lock- washers and hex nuts (D). NOTE: Holes (E) Fig. 2, in side panels (C) should be at the bottom of the stand during assembly.

2.Fig. 3, illustrates the stand completely assembled.

3.Assemble mounting leg (F) Fig. 4, to each corner of the stand as shown, with 4 one inch-long screws, flat washers, lockwashers and hex nuts (G).

ASSEMBLING MACHINE TO STAND

1.Carefully place machine (A) Fig. 5, on stand (B).

2.Align four holes in the base of the machine (A) Fig. 5, with four threaded holes in top of stand (B) and fasten with 4 one inch-long screws, lockwashers and flat washers, three of which are shown at (C).

5

B

C

C

EDA

Fig. 2

Fig. 3

F

F

F

F

G

Fig. 4

A

C

C

B

Fig. 5