Delta 32-350 instruction manual Assembling Table to Machine, Assembling Miter Gage

ASSEMBLING

TABLE TO MACHINE

1.Thread two lock knobs (A) Fig. 6, into holes (B) at the underside of table (C).

2.Place table (C) Fig. 7, onto ledge (D) Fig. 8, of machine. Align two holes in machine ledge (D) Fig. 8, with two threaded holes in the underside of table (C) and fasten as shown, with 2 one inch-long screws, lockwashers and flat washers (E) Fig. 8.

C

D

Fig. 7

ASSEMBLING

MITER GAGE

1.Remove knob and flat washer (A) Fig. 9, from threaded rod of miter gage bar (B).

2.Place miter gage body (C) Fig. 10, over threaded rod of miter gage bar (B) and reassemble flat washer and knob, which were removed from miter gage bar (B) in STEP 1. NOTE: Make certain pin (D) Fig. 9, located on

u n d e r s i d e of miter gage body (B) engages hole (E) in miter gage bar

(B) when assembling miter gage.

A

A

BC

Fig. 6

E

C D

Fig. 8

E

BA

D

Fig. 9

C

A

B

6

Fig. 10