3Installation
3.1Drilling the Support surface and Fitting the Hood
Screw Fitting
•The hood support surface must be 135 mm above the bottom surface of the wall units.
•Drill the support with a ø 4,5 mm drill bit, using the drilling template provided.
•Cut a hole ø 150 mm in size on the support surface, using the drilling template provided.
•Fix using the 4 screws 12a (4,2 x 44,4) provi- ded.
Snap-On Fitting
•The hood can be installed either directly on the bottom surface of the wall units using
•Cut a fitted opening in the bottom surface of the wall unit, as shown.
•Insert the hood until the side supports snap into place.
•Lock in position by tightening the screws Vf from underneath the hood.
| Hood Type | CTB 6250 XA | CTB 9250 XA |
|
|
|
|
|
|
| L1 | 510 | 810 |
|
|
|
|
|
|
Hood / User Manual | 7 / 11 EN |
|
|
