ALIGNING TABLE 90 DEGREES TO THE DRILL BITS
1.Make certain the machine is disconnected from the power source and air supply.
2.With the drill bits in position, manually push the car- riage forward as far as it will go.
3.Place a square (A) Fig. 22, against rear fence (B) and drill bits (C) as shown and check to see if the table is aligned 90 degrees to the drill bits.
4.If an adjustment is necessary, loosen two screws (D) Fig. 23, and align table (E) Fig. 22, so it is 90 degrees to drill bits (C). Tighten two screws (D) Fig. 23, after adjustment is made.
5.Recheck the drilling depth setting.
STARTING AND STOPPING DRILL ROTATION
1.To start drill rotation, push green start button (A) Fig. 24.
2.To stop drill rotation, push red stop button (B) Fig.
3.IMPORTANT: The air supply must be on and the foot pedal depressed to lower work holddown and activate carriage movement.
C B E
A
Fig. 22
D
Fig. 23
A
B
Fig. 24
11
