OPERATION
Figs. 33 and 34, illustrate a typical end boring operation. Note that work holddown (A) Fig. 33, has been adjusted to hold workpiece (B) down on the table and that the end
of workpiece (B) is firmly held against table fence (C) and miter gage (D).
Figs. 35 and 36, illustrate a typical two hole side boring operation. Note that work holddown (A) Fig. 35, has been adjusted to hold workpiece (E) down on the table and that workpiece (E) is firmly held against the table fence and stock stop (F).
Fig. 37, illustrates the end piece (B) with dowel rods (G) inserted, about to be assembled to workpiece (E).
Fig. 36
14
A
C
B
D
Fig. 33
Fig. 34
A
F
E
Fig. 35
G
B
E
Fig. 37
