OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Suitable Use of Your Pressure Washer
Correct Use of the Pressure Washer
Maintenance & Cleaning
Lubrication: The pressure washer is supplied with a closed lubrication system, so no addition of oil is needed.
Checking the Water Intake Filter: The water intake filter is located inside the water intake connector. (Fig. 10) Remove periodically and inspect for any deposits that might accumulate there.
Cleaning the Nozzles: If you notice that the output pressure fluctuates, you may have to clean the nozzles. Turn the unit "Off". Unplug from electric outlet and disconnect the water supply. Remove the lance and hose with the trigger gun from unit. Take the small metal pin provided and insert into the nozzle end to remove any obstructions. (Fig. 11)
This high pressure washer is suitable for
The high pressure washer is suitable for washing with cold water only. The water that you use for the pressure washer must not be dirty, sandy or contain any corrosive chemical products.
•Place the pressure washer in a safe area and on a horizontal surface.
•When using the pressure washer, hold the trigger gun firmly with one hand on the handle and the other on the lance. (Fig. 1)
Hose Connector | Fig. 11 |
Water Intake | |
Fig. 10 | This will occur more frequently if your |
| water supply is very hard. |
7
The pressure washer may be used to wash shutters, doors, tiles, cars, decks, campers, etc., where high water pressure is necessary to remove dirt.
With the detergent applicator bottle, the pressure washer can be used to apply a thick coating of aerated detergent to the areas being cleaned .
With the sandblasting kit, the pressure washer can be used to remove surface rust, strip paint from metal and concrete. When using the pressure washer we recommend the use of personal safety items to reduce the risk of accidental injury.
Unpacking Your Pressure Washer
After you open the package, check to make sure that all the parts are in the box as per parts that illustrated on page 3 of this guide. Due to transport and packing restraints, some accessories may be supplied unassembled; in this case follow the assembly instructions in this manual. If you have any questions, call Customer Service at 1 (800)
4
Fig. 1
•NEVER point the water jet or sandblasting lance at electric wiring, at the pump unit, or at any person or animal.
Assembling the Pressure Washer
1.Carefully take the pressure washer and all accessories out of the packaging.
2.Snap wheels onto the unit. (Fig. 2)
3.Attach the handle to the unit with the screw supplied using a Phillips screwdriver. (Fig. 2)
Fig. 2
AUTOMATIC STOP SYSTEM
PLEASE NOTE: This pressure washer is equipped with the Automatic Stop System, which stops the unit during the bypass stage. To start the pressure washer, it is therefore necessary to set the On/Off switch to the “On” position; after that press the trigger: the Automatic Stop System will start the machine and will stop it automatically when the trigger is released. It is advisable to put on the safety lock of the trigger whenever the machine is stopped in order to avoid unintentional starting. Any automatic start of the machine without pressing the trigger is
