FARGO electronic DTC300M, DTC400 manual Placing the Printer in the Firmware Upgrade Mode

RESTRICTED USE ONLYFargo Electronics, Inc.

Placing the Printer in the Firmware Upgrade Mode

Step	Procedure
1
		Caution: Turn off the Printer and unplug the power cord from the
	Printer.
2	Press and hold down the Power and Pause buttons on the Printer, as shown
	below.
3	Continue to hold down both the Power and Pause buttons as the power is
	reapplied, hold the buttons down for two (2) seconds after the power has been
	restored and then release. (Note: The LCD display should now show the
	Upgrade Firmware message, as shown below).
4	Press the Yes button on the LCD to continue with the Firmware Upgrade.

DTC400/DTC300/DTC300M Firmware Upgrade Document (Rev. 1.3) 19