| 190 |
| 200 |
| 220 |
Paper shredder | 220 CC |
|
|
8. Checklist for Inoperative Machine
If the equipment does not work properly, please check the following points first:
–Is the plug inserted ?
–Is the switch turned on ?
–Is waste container pushed in properly ?
–Is waste container full ? Empty container
–Is there a paper jam in the shredder ? See Malfunctions
–Is the motor overheated ?
Switch machine off and allow motor to cool down for approximately
If none of the above applies and the equipment still does not run, please contact the appropriate customer service department.
9. Malfunctions
Door contact interrupted
Red LED lights (220 series only).
No LED on 190 & 200 models.
– Paper shredder switches off automati- cally. Press rocker switch to center (2)
2 position.
•Check whether cut material container is properly pushed into bottom frame.
1 | • Return switch to "on" position (1) and |
| continue shredding. |
Cut material container full
Red LED lights (220 series only).
No LED on 190 & 200 models.
–Paper shredder switches off automati- cally.
• Press rocker switch to center (2)
2
position.
Paper jam
2
3
•Press rocker switch to center position
(2) to stop the cutting system.
•Press and hold down rocker switch in pos. (3) to reverse the cutting system and back out jammed material (paper is pushed out)
•Empty cut material container or exchange cut material bag.
•Return switch to "on" position (1) and
1
continue shredding.
10. Maintenance
| Caution! |
1 | Do not press rocker switch alternately |
3 | forwards/backwards in pos. (1 and 3) |
| • Remove excess paper. |
1 | • Return switch to pos. (1) and continue |
| shredding in smaller quantities so as |
| not to jam the machine further. |
(Cross cut unit only)
–When tearing capacity drops or the noise increases:
•Spray special cutting block oil onto cutting system.
•Run cutting system forward (1) and
1 | backward (3) several times without |
3 | feeding paper. |
|
• Continue shredding.
Edition 09/98 | 1.294.999.110 | 7 |
USA
