ADTRAN ISU 512 user manual Test Remote, Maintenance Setup

Chapter 5: Configuration

Test Remote

When the Test Remote option is enabled the unit performs an automatic 2047 BERT of the line(s) immediately following BONDING connection. When dis- abled (default), no test is performed after initialization.

Maintenance Setup

There are three Maintenance Setup options: Auto Traps, ADLP Address, and Port Mode.

Auto Traps

The Auto Traps option is for use with Port Mode=ATEL. The ISU 512 monitors and reports alarms for network failures or degrading performance conditions. The ISU 512 can be configured to generate protocol traps autonomously by se- lecting Enable. To disable protocol traps, select Disable. The ISU 512 sends a trap for the following conditions:

ISDN #1, #2, #3, #4 Link Down ISDN #1, #2, #3, #4 Link Up

Data Call connected at unexpected data rate. (less than expected)

ADLP Address

Select ADLP Address to enter an ADLP address to the ISU 512 as required for use with ADTRAN T-Watch Management Software. This address is used when the ISU 512 maintenance port is programmed for ADLP or ATEL mode.

Port Mode

Port Mode allows the unit to be set for VT 100 terminal (default) or ADLP/ ATEL mode for use with ADTRAN T-Watch or ADVISOR SNMP software packages. Selecting ADLP allows the ISU 512 to use the ADTRAN Data Link Protocol which is used to send T-Watch commands between the PC and the ISU 512. Selecting ATEL allows the ISU 512 to use ADLP/ATEL protocols to communicate with the ADTRAN ADVISOR SNMP software. Use the follow- ing menu path to access Maintenance Setup for Dial Line operation:

3=CONFIG 1=Netw. options

2=Leased Line 4=Maint. Setup

1=Auto Traps 2=ADLP Address 3=Port Mode

61202.086L1-1 ISU 512 User Manual 41