Appenidix B.
S34 . . . .DTE DTR. . . . . . . . . . . . . Determines how the ISU 512 responds to changes in DTR.
0=Ignore DTR (default)
2=Dump incoming call when DTR is off
S35 . . . .DTE CONN . . . . . . . . . . . Determines which is the current operating DTE connector.
0=V.35 connector (default)
S40 . . . .BOND TXINIT . . . . . . . . Specifies the number of seconds the originating end point attempts to detect the BONDING negotiation pattern from the answering end point before deciding the BONDING call has failed. 0 to 256, 10 sec is default.
S41 . . . .BOND TXFA. . . . . . . . . . Specifies the number of seconds both end points attempt to detect the BONDING frame pattern when a call is connect- ed before deciding the BONDING call has failed. When operating with other manufacturer's BONDING equipment it may be necessary to lengthen this timer so that it matches TXADD01. 0 to 256, 10 sec is default.
S42 . . . .BOND TXADD01 . . . . . . The number of seconds both end points wait for the addi- tional call to be connected at the end of negotiation before deciding the BONDING call has failed. When dialing over- seas, it may be necessary to lengthen this timer to allow for lower call routing. 0 to 256, 50 sec is default.
S43 . . . .BOND TXDEQ . . . . . . . . The number of seconds both end points attempt to equalize the network delay between the bearer channels before de- ciding the BONDING call has failed. 0 to 256, 5 sec is de- fault.
S44 . . . .BOND TANULL . . . . . . . The number of seconds the answering end point attempts to detect the BONDING negotiation pattern from the origi- nating end point before aborting to clear channel mode. It may be necessary to shorten this timer if the DTE equip- ment connected to the ISU 512 also has timer constraints for completing
80 | ISU 512 User Manual |
