| 480 |
| 480 CC |
Paper shredder | 480 HS |
|
|
8. Checklist for Inoperative Machine
If the equipment does not work properly, please check the following points first:
–Is the plug inserted?
–Is the switch turned on?
–Is the cabinet door closed?
–Is waste receptacle full? Empty waste bag.
–Is there a paper jam in the shredder?
–Is the motor overheated?
Switch machine off and allow motor to cool down for approximately
If none of the above applies and the equipment stil does not run, please contact our customer service department.
9. Malfunctions
Motor Overheating
Red LED lights
Paper shredder switches off automati- cally.
| • Tap rocker switch pos. 2 | ||
2 |
| ➪ | Rocker switch resets to zero |
|
|
| position |
| • Allow shredder to cool down for | ||
|
| approximately | |
1 | • | Return switch to "on" position (1) | |
|
and continue shredding.
Cabinet door ajar / bag full
Red LED lights
Paper shredder switches off automati- cally.
Paper jam
• Tap rocker switch pos. 2
Red LED lights
2
➪ Rocker switch resets to zero position
2
•Press and hold down rocker switch in pos. 2 to reverse the cutting system and back out jammed material (paper is pushed out)
•Make sure cabinet door is properly closed and/or empty waste bag.
1 • Return switch to "on" position (1) and continue shredding.
|
|
|
|
|
|
| Caution! |
|
|
|
|
|
|
| Do not attempt to force the jammed |
|
|
|
|
|
|
| material through the machine by |
|
|
|
|
|
|
| |
|
|
|
|
| 1 | alternating the cutting system between | |
|
|
|
|
| |||
|
|
|
|
|
|
| |
|
|
|
|
| 2 | forward and reverse | |
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
|
|
| • Remove excess paper |
|
|
|
| 1 |
| • Return switch to pos. 1 and continue | |
|
|
|
|
| |||
|
|
|
|
|
|
| shredding in smaller quantities so as |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| not to jam the machine further |
|
|
|
|
|
|
|
Note:
The 480 HS will not run forward again unless the jammed material has been completely removed from the throat
10. Maintenance
(Cross cut unit only)
–When shredding capacity drops or the noise increases
•Spray special cutting block oil onto cutting system
1 | • | Run cutting system forward and |
2 |
| backward several times without feeding |
|
| paper |
| • | Continue shredding |
Edition 02/02 | USA | 7 |
|
|