Fellowes DM8C manual Set-Up, Operation, To shred, English

ENGLISH

Set-Up

For safety reasons, this model will operate only if the shredder head (6) is in the correct position on the cabinet (2) and used with supplied basket (3).

•Position shredder head over cabinet. Place shredder head on top of cabinet as shown in Figure A.

•Firmly push down on four corners of shredder head to "lock" shredder head into position. •Push basket into shredder cabinet as shown in Figure B.

Note: To disassemble, pull out basket, hold cabinet down by placing foot on bottom shelf, and firmly pull up on shredder head.

Operation

For convenience, your shredder is equipped with an automatic-start sensor (8). This means that when the control switch (5) is in the automatic [I] position, the shredder will start running when you put paper into it and stop a few seconds after the paper has passed through. Because the sensor cannot tell the difference between paper and other objects, this feature can also be a hazard, especially to children and pets. To avoid acci- dents, turn off the shredder as soon as you are finished. Unplug shredder if it will not be used for an extended period.

To shred

•Plug in shredder with control switch (5) in off [O] position.

•Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds to signal readiness and green light (4) will turn on.

•Feed paper straight into entry (1), until the shredder automatically begins shredding; see Product Profile for limits on paper width, shreddable items, sheet capacity, etc.

•Shred for no more than 20 minutes; shredding longer will cause the overheat light (9) to go on and the shredder to turn itself off for 30 minutes to cool down.

•Press control switch to off [O] position after shredding has stopped.

In case of a paper jam, which may occur if the shredder is pushed beyond its specified capabilities, press the control switch to the off [O] position and empty the basket if full. Then:

1)Press and hold control switch in reverse [R] position and attempt to back paper out of shredder.

2)If shredder jams in reverse mode, press control switch to automatic [I] position and attempt to continue shredding operation.

3)If shredder jams again, alternate control switch slowly between reverse [R] and automat- ic [I] positions to attempt to move jammed paper completely through shredder.

If you are unable to clear the jam using this method, turn off and unplug the shredder; remove the wastebasket from cabinet and carefully remove any paper extending below the cutting cylinders; empty the wastebasket; insert wastebasket and repeat jam clearing pro- cedure.

4