Ferris Industries 5900619 IS2000ZKAV2561, 25HP, 61 CUT ZERO-TURN RIDING MOWER, 5900624 IS2000ZKAV2552, 25HP, 52 CUT ZERO-TURN RIDING MOWER, 5900625 IS2000ZK2752, 27HP, 52 CUT ZERO-TURN RIDING MOWER, 5900629 IS2000ZLKAV2661, 26HP, 61 CUT ZERO-TURN RIDING MOWER, 5900670 IS2000ZBV3061, 30HP, 61 CUT ZERO-TURN RIDING MOWER, 5900713 IS2000ZKAV25/52 AUS/NZ, 25HP, 52 CUT ZERO-TURN RIDING MOWER, 5900714 IS2000ZKAV25/61 AUS/NZ, 25HP, 61 CUT ZERO-TURN RIDING MOWER, 5900715 IS2000ZBV30/61 AUS/NZ, 30HP, 61 CUT ZERO-TURN RIDING MOWER, 5900737 IS2000ZKAV2561 CAL, 25HP, 61 CUT ZERO-TURN RIDING MOWER, 5900738 IS2000ZBV3061 CAL, 30HP, 61 CUT ZERO-TURN RIDING MOWER, 5900750 IS2000ZKAV2761, 27HP, 61 CUT ZERO-TURN RIDING MOWER, 5900754 IS2000ZKAV3461SS, 34HP, 61 CUT ZERO-TURN RIDING MOWER, 5901170 IS2000ZK2761, 27HP, 61 CUT ZERO-TURN RIDING MOWER CHECK ENGINE COOLANT LEVEL, CHANGE ENGINE COOLANT, CLEAN RADIATOR & SCREEN

30 www.ferrisindustries.com

Maintenance

Regular Maintenance

WARNING

PRESSURIZED SYSTEM

Hot coolant can cause serious burns. Never

open the radiator cap. Wait until the engine is

cool before checking the coolant level or

removing the reservoir cap.

CHECK ENGINE COOLANT LEVEL

The engine coolant level and quality should be

checked before each use, when the engine is cool

and off.

The cooling system is a closed type. Never open the

radiator cap. Doing so may induce air into the cooling

system and may cause overheating.

1. Check the coolant level only at the overflow

reser voir (A, Figure 18). The coolant level should

be between the “H” and “L” marks.

2. If the coolant level is insufficient, remove the cap

(B) from the reser voir and add coolant to the “H”

mark.

3. Reinstall the cap.

NOTE: Proper coolant mix is a 50/50 mixture of

ethylene glycol and distilled water. See engine

owners manual for engine coolant specifications.

CHANGE ENGINE COOLANT

See engine owners manual for specific engine coolant

change procedures.

CLEAN RADIATOR & SCREEN

Clean the radiator and screen before each use, or as

required (depending on conditions) to allow proper

air-flow through the radiator.

1. To remove the radiator screen, lift the seat.

2. Release radiator screen latch (C), slide towards

the left hand side of the machine. Lift screen

enough to clear radiator cap and slide out the

front.

3. Flush the screen with water or blow clean with air.

Flush the radiator core with water or blow clean

with air. See engine owners manual for proper

radiator cleaning procedures.

4. To reinstall the radiator screen, reverse removal

process.

Figure 18. Radiator, Screen & Overflow Bottle

A. Overflow Reservoir

B. Reservoir Cap

C. Radiator Screen Latch

D. Radiator Screen