Installation Instructions
Derby Stallion Oil Cooler Kit
Part No. 1846197
For all Derby Stallion ZT2354 mowers
This kit is for installing oil coolers to the hydraulic system. This kit should be installed when using the Triple Bagger Grass Collection System.
Kit Contents:
Ref | Part No. | Qty. | Description |
1 | 22467 | 2 | Oil Cooler |
2 | 1846152 | 1 | Mount |
3 | 1846153 | 1 | Mount |
4 | 1846154 | 1 | Oil Cooler Mount |
5 | 22106 | 2 | 3/8” Hose Fitting |
6 | 21164 | 4 | Hose Clamp |
7 | 25299 | 8 | Bolt, |
8 | 25095 | 8 | Nut, |
9 | 1 | 3/8” Hose, 19” (not shown) | |
10 | 1 | 3/8” Hose, 25” (not shown) | |
11 | 2 | 3/8” Hose, 48” (not shown) | |
12 | 1 | 3/4” Wire Loom, 18” (not shown) | |
12 | 1 | 3/4” Wire Loom, 24” (not shown) | |
13 | 21029 | 3 | Long Tie Wrap (not shown) |
14 | 21030 | 1 | Short Tie Wrap (not shown) |
WARNING
Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).
REMOVAL & INSTALLATION
1.Park machine on a flat, level surface and engage the parking brake.
2.Remove and discard the fuel tank tie bar and the left and right mounting brackets. SAVE the mounting hardware.
3.Remove the split collars from the control cross shaft and carefully lift the shaft assembly from the saddles. Set the shaft on the ledge of the rear seat support to allow for increased access room.
4.Subassemble the 19” and 25” hose lengths with one of the barbed fittings on each hose and the appropri- ate length of wire loom. Be sure the barbs are fully inserted into the hose end. Applying a few drops of oil on the barbs will make the assemble easier.
1 | 2 | 3 |
|
| 5 |
|
| 6 |
|
| 7 |
| 4 |
|
|
| 8 |
Figure 1. Kit Contents
Figure 2. Fitting Orientation
NOTE: Some oil loss will occur when disconnecting the hydraulic hoses. Remove and reconnect as quickly as possible and prepare to contain the lost oil.
5.Remove the right return hose and loosen the jam nut on the fitting on the pump. Rotate the fitting towards the rear of the machine and point it slightly upwards (see Figure 2). Tighten the jam nut.
6.Install the 19” hose assembly to the fitting on the pump and tighten. Leave the free end of the hose higher than the reservoir to prevent to hydraulic sys- tem from draining.
| 1 | 1846261 |
© Copyright 2000 Ferris Industries. All Rights Reserved. | Rev. 9/2000 | |
| TP |
