![Installation Instructions](/images/new-backgrounds/92561/925615x1.webp)
Installation Instructions | 1846197 |
19. Refill the oil reservoir to the “MAX OIL LEVEL HOT” |
|
| |
line. Use either Mobil 1, |
|
Castrol Syntec |
|
oils. Make sure area around the reservoir is free of |
|
dust, dirt, or other debris. |
|
20. Reinstall the left drive tire and remove the jack |
|
stands. Lower the seat plate. |
|
21. Make sure the parking brake is engaged, the control |
|
handles locked in the “NEUTRAL” position and the |
|
PTO switch is off. Reconnect the spark plug wires. |
|
22. Start the engine and run it in the slowest throttle |
|
position. Dismount the machine and raise the seat |
|
plate. |
|
23. Carefully watch the oil level in the reservoir while the |
|
machine in running. The level will initially drop quick- |
|
ly as the oil coolers are being filled. Do not allow the |
|
oil level to drop below 50% of the full capacity.
Figure 6. Tie Wrap Location
24. With the cap removed, look through the filler neck of the oil reservoir and watch for oil flow at the return line barbs. Once there is a continuously flow of oil, the return side of the hydraulic system has been filled. If necessary, fill the oil reservoir to 1/2” below the “MAX OIL LEVEL HOT” line.
25. Replace the oil reservoir cap and lower the seat plate.
© Copyright 2000 Ferris Industries. All Rights Reserved. | 3 |