Field Controls SWG Stainless, SWGII Replacement Parts, Part Numbers, Model, Repair Motor Assembly

REPLACEMENT PARTS

Should the motor or blower wheel need replacing, the following replacement items are available. The Repair Motor Assembly contains the Motor and Blower Wheel factory assemble to a mounting bracket.

	PART NUMBERS
MODEL	REPAIR MOTOR ASSEMBLY	BLOWER WHEEL
SWG-3	46196601	46131800
SWG/SWGII-4HD	46234800	46310400
SWG-4s
SWG/SWGII-5	46234900	46213800
SWG-5s
SWG/SWGII-6	46235000	46385800
SWG-6s
SWG-7	46152401	46154700
SWG-8	46460101	46154800

SWG Repair	SWGII Repair	Blower
Motor Assembly	Motor Assembly	Wheel

REMOVAL AND INSTALLATION OF THE SWG SERIES POWER VENTER MOTOR ASSEMBLY

REMOVAL

1.Remove the screws securing the motor enclosure cover. (See Figure 9)

2.Remove the screws securing the motor assembly. Rotate the motor assembly counter-clockwise and slide the assembly into the center. Then pull the motor assembly out of the unit. (See Figure 10)

3.Clean off any build-up inside the blower wheel housing and the blower wheel. CAUTION: Avoid applying excess pressure on the blower wheel when cleaning off any build-up of material. This will cause an imbalance of the blower wheel which will result in excessive vibration and premature motor failure.

4.If replacing the motor assembly with a new assembly, disconnect the conduit from the old motor and cut the wires close to the motor. The new motor assembly will have an electrical box and connector for the conduit.

Figure 9

Figure 10

Page 9