3.Disconnect the lamp connection, then rotate
4.Remove lamp carefully, by
NOTE: When replacing the lamp, always wipe off lamp with the supplied alcohol wipe before installing.
5.Plug the new lamp onto the
6.Guide the other end of the lamp through the hole in the UV chamber. (See Figure 11)
7.Secure the lamp into position by rotating the
8.Plug the lamp power leads back into the power connection. (See Figure 10)
NOTE: UV lamps contain a small amount of mercury, like a typical fluorescent lamp. According to the EPA’s Universal Waste Rule, these types of lamps may be disposed of into household waste. Check with your local waste management authority for local disposal or recycling requirements.
9.Close the access door and install the access door screw. (See Figure 8)
10.Plug the power cord back into the wall receptacle or restore power to the
11.Use the point of a pen or paper clip to press the “reset” button beside the lamp LED. (See Figure 13)
12.Lamp LED will turn from “RED” to “GREEN” and the display will say “LAMP: 365 DAYS”.
REPLACING AIR FILTERS
1.Pull the drawer out at the base of the unit and remove the old filter.
2.Remove the filter from its plastic bag and place the filter into the tray of the drawer with the black carbon facing up.
3.Use the point of a pen or paper clip to press the “reset” button beside the filter LED.
4.Filter LED will turn from “RED” to “GREEN” and the display will say “FILTER: 90 DAYS”.
VII. REPLACEMENT PARTS KIT
Figure 10
Figure 11
Figure 12
Figure 13
For replacement parts, contact your local heating service company. Any
questions, please contact Field Controls at:
PHONE:
SALES@FIELDCONTROLS.COM
Limited Warranty
Field Controls, L.L.C. warrants that the following Field Controls, L.L.C. products sold hereunder, shall be free from defects in material and workmanship under normal use for eighteen (18) months from date of manufacturing by the consumer excepting the provisions numbered below.
Field Controls, L.L.C. warrants that the following Field Controls, L.L.C. products sold hereunder, shall be free from defects in material and workmanship under normal use for ninety (90) days from date of installation by the consumer excepting the provisions numbered below.
Provisions:
1.Field Controls shall have no obligation in the event the customer is unable to provide receipt showing the date the customer purchased the product(s) or accurate date code information.
2.The product must be properly installed, maintained and operated under normal conditions.
3.Field Controls shall not be liable for any consequential and incidental damages, resulting from failure of a Field Controls, L.L.C. product, failure to deliver, delay in delivery, delivery in nonconforming condition, or for any breech of contract or duty between Field Controls, L.L.C. and the customer.
4.Field Controls, L.L.C. products are often intended for use in specific applications. Field Controls, L.L.C. makes no warranty if a Field Controls, L.L.C. product is used in applications other than intended.
5.Field Controls, L.L.C. makes no warranty of any kind in regard to any other manufacturer’s products distributed by Field Controls, L.L.C. Field Controls, L.L.C. will pass on all warranties made by the manufacturer and where possible, will expedite the claim on behalf of the customer, but ultimately, responsibility for disposition of the warranty claim lies with the manufacturer.
The health aspects associated with the use of these products and their ability to aid in disinfecting of environmental air have not been investigated by UL.
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the