FilterStream V2210 Cleaning/Replacing Foam And Hepa Filters, Foam Filter Cleaning

M A I N T E N A N C E / F I L T E R R E P L A C E M E N T

CLEANING/REPLACING FOAM AND HEPA FILTERS

To remove/replace the Filter (either foam or HEPA) from the vacuum, please follow these steps:

(a) Remove the Filter Cover from the

vacuum Handle/ a Housing.

(b)Remove the Filter

from the Handle/ Housing.

(c)Clean the Filter as follows.

Foam Filter Cleaning:

Wash the Foam Filter in b

warm, soapy water until clean. Allow the Foam Filter to dry before reinserting into the Handle/Housing.

Note: Use only mild soap. Avoid detergents,

chemical cleaners or solvents as these may damage the plastic.

HEPA Filter Cleaning: Use your finger to lightly clean the paper surface of the HEPA Filter, clearing off any dirt, dust, and hair.

NOTE 1: Do not wash the HEPA Filter. Water will permanently damage the filter.

NOTE 2: Under normal household use, the HEPA Filter will last over one (1) year.

(d)Insert either side of the clean Filter (or if necessary, a new Filter) into the Handle/ Housing, then snap-on the Filter Cover and reattach the Bowl to the Handle/Housing (making sure that the Pre-Filter is inserted into the Bowl).

NOTE: Filters should be replaced periodically to provide best performance or when the filter has been damaged.

17