VI. Wavelength Stabilization

FWDM-1629-XX DWDM SFP Preliminary Product Specification – February 2005

F i n i s a r

The laser transmitter will not be turned on until its temperature is adjusted to ensure operation within the specified channel (X +/- 0.4nm). This temperature stabilization time is dependent on the ambient temperature conditions, but will typically occur within 90 seconds of powering the device. The device will transmit within the specified wavelength tolerance (X +/- 0.1nm) within 5 seconds of transmitter operation.

VII. General Specifications

Parameter	Symbol	Min	1.25	Max	Units	Notes/Conditions

Data Rate	BR	1.06		1.25	Gb/sec	Fibre Channel, IEEE 802.3
						compatible
Total System Budget		30	32		dB	@ 1.25 Gb/s, BER <10-12w/
						PRBS 2-7-1. See Note 1

Note 1: Total system budget is defined as Pout – Pin – typical connector losses.

VIII. Environmental Specifications

Parameter	Symbol	Min	Typ	Max	Units	Notes/Conditions

Operating Temp	Top	-5		70	°C	Case temperature measured on top-side of
						device
Storage Temp	Tsto	-10		85	°C	Ambient temperature
Eye Safety						CDRH and IEC-825 Class 1 Laser
						Product. See Note 1

Note 1: Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No. 50, dated July 26, 2001.

© Finisar Corporation	PRELIMINARY and Confidential	Page 7
Rev C, February 2005

Finisar FWDM-1629-XX manual VI. Wavelength Stabilization, VII. General Specifications

Models: FWDM-1629-XX

F i n i s a r