FireplaceXtrordinair 36A-BI, 36A-ZC manual Page

REPLACEMENT PARTS AND REMOVAL INSTRUCTIONS (Continued)

Removing and Replacing the Catalytic Combustor (Continued)

2.Reach into the firebox and remove the baffle that is along the roof of the firebox right behind the doors by sliding it backwards and then pivoting it down.

Remove the Baffle by Sliding it Backwards then Rotating it Down

3.Disconnect the combustor assembly from the combustor by- pass control rods. The combustor assembly will have to be rotated down to allow the two rods coming off of the assembly to disconnect from the combustor by-pass control rods.

4.Remove the mixing screen from the combustor assembly by pulling it up and off the two rods that stick out of the combustor assembly.

5.Remove the combustor assembly by rotating it down from the front and allowing it to slide off of the ledge that it sits on.

Combustor Assembly	Rotate Combustor
	Assembly Down

Combustor By-Pass Control Rods

Combustor Assembly

Remove

Mixing

Screen

6.To remove the existing catalytic combustor from the combustor assembly, push it out from the rear. Keep in mind that the catalytic combustor is ceramic, and that pressure should be exerted over a large surface to reduce any chipping. Remove any gasketing that may still be attached to the combustor assembly. Replace the catalytic combustor by pushing it in from the front. Make sure to keep the gasket that is attached to the new catalytic combustor from being damaged while it is inserted. Before re-assembling the combustor assembly to the fireplace, check the gasket on the combustor for wear. Replace it if necessary.

Combustor Assembly	Push the Old Catalytic Combustor Out of
	the Combustor Assembly from the Rear

Catalytic Combustor Check this Gasket for Deterioration

7.To re-assemble the combustor assembly, follow the directions in reverse order. Make sure to center and align the assembly before attaching the combustor by-pass control rods to the rods that come off of the combustor assembly.

Page 28