First Alert digital waterproof fire safe with ready-seal manual Programming a Personal Passcode

Test Locking System

TESTING THE PASSCODE

Programming A Personal Passcode

PROGRAMMING A PERSONAL PASSCODE

1	With the safe door open and the Live Bolts engaged, you can now
	test the Electronic Locking System using the pre-set three digit
	factory code. Locate the digital keypad on the front of the safe
	and open up the protective cover to expose the keypad.
2	When the cover is opened, the keypad is activated and the
	keypad backlight will turn on and remain on for approximately
	five (5) seconds. The keypad is still active even when the
	backlight turns off. It will turn on again when any key is pressed.
3	The pre-set three digit factory passcode is 159. Enter this

1	2	3
4	5	6
7	8	9
	0	#

For security reasons, it is very important that you program your own personal passcode into the digital lock. The factory code should be changed immediately.

To program your own unique three to eight digit (3-8) passcode, follow these steps:

Reset Button

passcode as follows:

* 1 5 9 #

NOTE: AFTER PRESSING THE RESET BUTTON, THE RED AND GREEN LIGHTS ON THE KEYPAD WILL FLASH TO INDICATE THE PROGRAMMING

IS AUTHORIZED AND YOU HAVE 10 SECONDS TO BEGIN.

1 Open the protective cover on the front of the safe to expose the keypad.

NOTE: ALL ENTRIES ARE ACCOMPANIED BY A BEEP AND

THE GREEN LIGHT WILL FLASH.

4After properly entering the entire sequence, the green light will turn on and the lock will click. You now have five (5) seconds to open the safe by turning the safe door handle upward to the right.

IMPORTANT IF HANDLE WILL NOT TURN

2	With the safe in the open position, press the small reset button located on
	the inside top edge of the door.
3	Enter your new three to eight digit (3-8) passcode followed by the # key.

P A S S C O D E #

Minimum 3 Digits

Immediately repeat the sequence, beginning with the new passcode followed by the # key.

If the handle will not turn to the right after the green light comes on, first turn the handle slightly back to the left until it stops, then turn upwards to the right again to open.

5Once the handle has been turned to the right, the live bolts will disengage and retract into the door. At this point you have successfully unlocked the safe and the door can be opened. Note: This waterproof safe may require additional force upon initial entry.

6Leave the safe door open and proceed to Programming a Personal Passcode.

IMPORTANT SECURITY LOCKOUT PERIODS

For added security, the safe will automatically lock out entry for 15 minutes after three (3) attempts to open with an invalid passcode.

15

MINUTES

P A S S C O D E #

4The green light will light up solid for 5 seconds, indicating your new passcode has been successfully entered.

5Your new passcode will now be comprised of the three to eight (3-8) digit sequence you selected, always followed by the # sign. The factory pre-set Passcode will no longer open the safe.

6You may change your passcode at any time by repeating the ! same steps.

7It is important that you write down your personal passcode

and secure it in a safe location away from the safe.

NOTE: IF YOU FORGET YOUR PERSONAL PASSCODE, ACCESS TO THE SAFE CAN BE MADE USING THE EMERGENCY OVERRIDE KEY.

IMPORTANT	ONCE YOUR PERSONAL PASSCODE IS PROGRAMMED, THE
	FACTORY PRE-SET CODE WILL NO LONGER OPEN THE SAFE.

5 6