First Alert digital waterproof fire safe with ready-seal Opening Your Safe for the First Time

Opening Your Safe For The First Time

OPENING YOUR SAFE FOR THE FIRST TIME

IMPORTANT FIRST TIME ACTIVATION

Your safe is ready for activation. To open the safe and prevent it from locking before completing the first-time activation, a solenoid deactivation safety device has been installed.

BATTERIES AND EMERGENCY OVERRIDE KEYS

Remove four (4) AA batteries and two (2) Emergency Override Keys. They are located in the protective styrofoam insert at the top of the box.

Test Locking System

ACTIVATE LOCK

1	Locate the small plastic Locking Pin on the
	inside of the safe door. Grip and pull out
	completely then dispose of properly.
2	Leave the safe door open and proceed to
	Electronic Locking System Test.

TEST LOCKING SYSTEM

ELECTRONIC LOCKING SYSTEM TEST

USER ACTIVATION

Install Batteries

1Turn handle upwards to the right and pull open the safe door. Note: This waterproof safe may require additional force upon initial entry.

2Slide the battery compartment cover forward and remove. The compartment is located inside the safe at the top of the door. Install the four (4) AA batteries. Make sure the batteries are installed in the proper direction as indicated in the battery compartment. Slide the cover back into place.

3After the batteries are correctly installed, the red and green lights located at

the top of the keypad on the front of the safe will blink twice, the keypad backlight will flash once and you will hear a single beep.

4Proceed to Activate Lock.

1	2	3
4	5	6
7	8	9
	0	#

BATTERY CONFIGURATION

– +

+ –

Green Light					Red Light
	1		2	3
	4		5	6
Keypad		7	8	9
Backlight			0	#

With the door still open, you can test the Electronic Digital Lock by manually activating the Locking System.

	1	2	3
Locking Push Button	4	5	6
	7	8	9
		0	#

To activate the Locking System, locate the locking push button on the inside of the safe door, push it in and turn the handle to the left. This will cause the live door bolts to extend out and into the locked position. Now with the door open and the live door bolts in the locked position, you may proceed to Testing the Passcode.

Dead Bolt	Extended Live Bolts
	Locking Push Button

IMPORTANT ENABLE/DISABLE SOUND

Once the batteries are installed, if you do not hear a beep when entering the factory pre-set passcode or during the personal passcode re-programming process, enter the following key sequence into the digital keypad:

#	*	#	This will turn the sound on. Repeat the
			process if you want the sound turned off.

Dead Bolt Extended Live Bolts

IMPORTANT ENGAGING LIVE BOLTS

Closing the safe door with the Live Bolts in the locked position can damage the safe. The locking push button should only be used when testing or programming the safe with the door remaining open.

3 4