LIMITATIONS OF HEAT ALARMS

This Heat Alarm is not a Smoke Alarm. This unit is not suitable protection when used alone. Do not use this unit as the only means of fire detection in a home. This unit is intended for use as a supplement to Smoke Alarms.

Heat Alarms are not life safety devices.

Heat Alarms are intended for use as supplements to Smoke Alarms. Because this unit cannot detect smoke, carbon monoxide or other toxic gases, do not rely solely on this Heat Alarm in a fire emergency. Slow developing fires may produce smoke and toxic gasses without a significant increase in room temperatures. For this reason, Heat Alarms are only to be installed as supplementary protection with Smoke Alarms.

Heat Alarms cannot work without power. AC powered Heat Alarms and Smoke Alarms cannot work if the AC power is cut off for any reason (open fuse or circuit breaker, failure along a power line or at a power station, electrical fire that burns the electrical wires, etc.).

AC units with battery (DC) back-up: will operate if electricity fails, provided the batteries are fresh and correctly installed. AC and AC/DC units must be installed by a qualified electrician.

Heat Alarms for Solar or Wind Energy users and battery backup power systems: AC powered Heat Alarms should only be operated with true or pure sine wave inverters. Operating this Heat Alarm with most battery-powered UPS (uninterruptible power supply) products or square wave or “quasi sine wave” inverters will damage the Alarm. If you are not sure about your inverter or UPS type, please consult with the manufacturer to verify.

Heat Alarms cannot sense fires if the heat does not reach them. Heat from fires in chimneys or walls, on roofs, or on the other side of closed doors may not reach the sensing chamber and set off the alarm. That is why one unit should be installed on every floor, in the attic, basement and garage and only as a supplement to Smoke Alarms.

Heat Alarms may not sense heat from a fire on another level of the home. Example: a stand-alone unit on the second floor may not detect heat from a fire in a crawl space until the fire spreads. This may not give you enough time to escape safely. That is why recommended minimum protection is at least one Smoke Alarm on every level of your home and Heat Alarms in any areas not suitable for Smoke Alarms. Even with a unit on every floor, stand-alone units may not provide as much protection as interconnected units, especially if the fire starts in a remote area. Interconnected units may provide earlier warning than stand-alone units since all units alarm when one senses heat or smoke.

Heat Alarms may not be heard. The alarm horn loudness meets or exceeds the current UL standard. However, if the device is installed outside the bed- room, it may not wake up a sound sleeper or one who has recently used drugs or has been drinking alcoholic beverages. This is especially true if the door is closed or only partly open. Even persons who are awake may not hear the alarm horn if the sound is blocked by distance or closed doors. Noise from traffic, stereo, radio, television, air conditioner, or other appliances may also prevent alert persons from hearing the alarm horn. This alarm device is not intended for people who are hearing impaired.

Heat Alarms may not have time to alarm before the fire itself causes damage, injury, or death, since heat from some fires may not reach the unit immediately. Examples of this include persons smoking in bed, children playing with matches, or fires caused by violent explosions resulting from escaping gas.

This Heat Alarm is not foolproof. Like any electronic device, Heat Alarms are made of components that can wear out or fail at any time. You must test the unit weekly to ensure your continued protection. Heat Alarms cannot prevent or extinguish fires. They are not a substitute for property or life insurance.

Heat Alarms have a limited life. The unit should be replaced immediately if it is not operating properly. In no case should it be used for more than 10 years.

LIMITED WARRANTY

BRK Brands, Inc., ("BRK") the maker of BRK® brand and First Alert® brand products warrants that for a period of ten years from the date of purchase, this product will be free from defects in material and workmanship. BRK, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive warranty.

This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. BRK dealers, service centers, or retail stores selling BRK products do not have the right to alter, modify or any way change the terms and conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than BRK or an authorized service center. Further, the warranty does not cover Acts of God, such as fire, flood, hurricanes and tornadoes or any batteries that are included with this unit.

BRK shall not be liable for any incidental or consequential damages caused by the breach of any express or implied warranty. Except to the extent prohibited by applicable law, any implied warranty of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. Some states, provinces or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state or province to province.

How to Obtain Warranty Service

Service: If service is required, do not return the product to your retailer. In order to obtain warranty service, contact the Consumer Affairs Division at 1-800-323-9005, 7:30 AM - 5:00 PM Central Standard Time, Monday through Friday. To assist us in serving you, please have the model number and date of purchase available when calling. For Warranty Service return to: BRK Brands, Inc., 25 Spur Drive, El Paso, TX 79906

Battery: BRK Brands, Inc. make no warranty, express or implied, written or oral, including that of merchantability or fitness for any particular purpose with respect to battery.

Please record Date and Where Purchased:

________________________________________________________________

BRK® is a registered trademark of BRK Brands, Inc.

First Alert® is a registered trademark of the First Alert Trust.

Printed in Mexico M08-0026-003 Q 08/08

8

Page 8
Image 8
First Alert HD6135FB user manual Limitations of Heat Alarms, Limited Warranty, How to Obtain Warranty Service

HD6135FB specifications

The First Alert HD6135FB is a state-of-the-art smoke and carbon monoxide alarm that combines advanced technology with user-friendly features. Designed to provide peace of mind for homeowners, the HD6135FB offers reliable performance and comprehensive safety monitoring.

One of its main features is the photoelectric sensor. This technology helps to reduce false alarms by quickly detecting smoldering fires that produce smoke without large flames. By distinguishing between different types of smoke, the HD6135FB minimizes unnecessary disruptions while still responding rapidly to genuine fire threats. Additionally, the unit includes an electrochemical CO sensor, which is highly sensitive in detecting carbon monoxide leaks, making it essential for safeguarding against this odorless and potentially deadly gas.

User convenience is prioritized in this model, as illustrated by its intuitive design. The First Alert HD6135FB comes equipped with a voice alarm feature, providing clear spoken warnings to alert homeowners to the specific danger—whether smoke or carbon monoxide. This audible notification ensures that residents can quickly respond to potential threats.

The device also boasts a battery-operated design, allowing for easy installation without the need for hardwiring. It is powered by lithium batteries, known for their long life, which reduces the frequency of battery changes. Additionally, the low battery chirp alerts users when it's time to replace the batteries, enhancing convenience and safety.

To make maintenance straightforward, this smoke and CO alarm includes a test/silence button. Homeowners can easily test the functionality of the device and silence false alarms with a single touch. Furthermore, the HD6135FB features a snap-on cover that streamlines battery replacements, minimizing the hassle associated with maintenance.

With its sleek design and compact profile, the First Alert HD6135FB is suitable for various home environments, easily blending with any decor. It is also equipped with an indicator light that provides a visual cue of the unit's operating status, ensuring residents are aware of its functionality at all times.

Overall, the First Alert HD6135FB represents a blend of cutting-edge technology, thoughtful design, and essential safety features, making it an excellent choice for homeowners committed to maintaining a safe living environment. Its integration of photoelectric and electrochemical sensors, along with user-friendly functionalities, establishes it as a reliable guardian against two of the most significant hazards in residential areas: fire and carbon monoxide.