SERVICE PROCEDURE
You may be asked to send your unit in for service.It will be necessary to furnish the following in order to have the product serviced and returned.
1.For Warranty Repair, include some form of
2.You must include the Public Alert System Receiver unit and power adapter.
3.Enclose a description of the problem with the unit. Include a typed or clearly printed name, address, and phone number where you can be contacted.
4.Pack the unit securely to prevent damage in transit. If possible, use the original packing material.
5.Ship the unit prepaid and insured by way of a traceable carrier (to avoid loss in transit) such as United Parcel Service (UPS), Roadway Parcel Service (RPS) or First Class Insured
Mail to:
Sima Products Corporation Attn: Customer Service
140 Pennsylvania Ave, Bldg #5 Oakmont, PA 15139
The Manufacturer is not responsible for units not received if the package has not been properly insured.
6.If the unit is in warranty, upon receipt of your unit it will either be repaired or exchanged.
Please allow approximately 2 to 4 weeks for your radio to be serviced. If the unit is out of warranty, we will notify you of the repair charge or replacement charge. If you have any questions, please call
FCC Notice to Users
The system may cause interference to a TV or radio even when it is operating properly. To determine whether the system is causing the interference, turn it off. If the interference goes away, the system is causing the interference. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
•Contact your dealer for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference that may cause undesired operation.
WARNING: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IMPORTANT!
Clear voice reception is important, but does not guarantee that an emergency alert will trigger your unit’s alert siren. To test actual reception and alert response, your unit must receive a test or emergency alert signal broadcast. The National Weather Service (NWS) broadcasts a test alert every week typically on Wednesday between 11AM and 12PM (noon). The radio will warn you if it has not received an alert within 10 days.
To find out the specific test schedule in your area, contact your local National Oceanic and Atmospheric Administration (NOAA) or National Weather Service (NWS) office -
http://www.nws.noaa.gov/nwr/
REMEMBER – FOR YOUR SYSTEM TO BE EFFECTIVE, YOU MUST PLACE IT WHERE IT CAN RECEIVE AN EMERGENCY ALERT SIGNAL AND WHERE YOU CAN HEAR ITS ALERT SIREN OR SEE ITS FLASHING LIGHTS.
28 | 5 |
