Firstech, LLC 2WSHLCD-5P Advanced System Functions, ’‰–…@lƒ‹@O@i‡Ž‰”‰Ž@cŽ”’ŒŒ…„@d’@lƒ‹“

Advanced System Functions

The following section reviews advanced system functions. Many of these functions require multiple steps or additional programming by your local authorized CompuStar dealer to be active.

d’‰–…@lƒ‹@O@i‡Ž‰”‰Ž@cŽ”’ŒŒ…„@d’@lƒ‹“

Tap buttons (I+IV) simultaneously for 0.5 seconds to turn on and off drive lock (also known as ignition controlled door locks). The remote will beep once and the drive lock icon will illuminate to confirm that drive lock mode is activated. The remote will beep twice and the drive lock icon will disappear to confirm drive lock is off.

IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has two settings;

Default 1: Off

Option 2: Locks the doors when the ignition is on and after the brake is depressed.

Option 3: locks the doors when the RPM s have reached two times that of idle speed (this setting requires that a tachometer wire is connected).

With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual transmission vehicle, the doors will unlock upon setting the emergency / parking brake.

Advanced System Functions

t•’‚@t‰…’@m„…

This feature can not be turned on with the 2 Way remote. The built in turbo timer keeps the vehicle’s engine running for either 1, 2, or 4 minutes (programmable from dealer with Option 2-2) after the vehicle key has been removed from the ignition. This feature will keep oil running through the turbo system to allow for appropriate cooling time. Tap the Trunk and Key buttons simultaneously for 0.5 seconds to turn on or off turbo mode. “on 1 way remotes”

IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the CompuStar system. Consult your local authorized CompuStar dealer for installation.

RŽ„ c’@m„…@Hm•Œ”‰Œ…@v…ˆ‰ƒŒ…@cŽ”’ŒI

2 n d	The 2W900FMR-2nd-5P remotes have the ability to operate a 2nd vehicle. Tap buttons (III+IV) simultaneously for 0.5 seconds to turn
	on or off 2nd car mode. The remote will beep once and the 2nd car icon will illuminate to confirm that 2nd car mode is activated. The

remote will beep twice and the icon will disappear to confirm 2nd car mode is off.

IMPORTANT: 2nd car mode requires the remote to be programmed to a 2nd vehicle that is equipped with either a 2W900FM-AS(DT), 2W900FM-S(DT), or 2W900FM-A(DT).

ByFirstech,LLC 28 29 ByFirstech,LLC