Firstech, LLC 2WSHLCD-5P Remote Coding / Programming Routine S, Remote Start Error Diagnostic

Remote Coding / Programming Routine (S)

IMPORTANT: Every CompuStar Pro remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.

p’‡’‰Ž‡@@RwYPPfmrMRŽ„MUp

STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7 seconds. The vehicle s parking lights will flash once with the successful completion of this step.

STEP 2: Within a 5 to 2second period after cycling the ignition for the 5th time, press button (I) on two-way remotes or the (lock) button on one-way remotes for 0.5 seconds. The parking lights will flash once to confirm the transmitter has been coded.

Exiting Programming: Programming is a timed sequence. The parking lights will flash twice signaling the end of programming mode.

Programming Multiple Remotes: After the confirmation flash given in step 2, code additional remotes by pressing button (I) on two-way remotes or the (lock) button on one-way remotes. The parking lights will flash once confirming each additional remote. All systems can recognize up to three remotes.

Remote Start Error Diagnostic

If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash again corresponding to the error table.

Number of Parking Light Flashes	Remote Start Error
1	Motor running
2	Key in ignition on position
3	Door open (manual transmission only)
4	Trunk open
5	Foot brake on
6	Hood open
7	Reservation off (manual transmission only)
8	Tach or voltage sensing failure

We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.

ByFirstech,LLC 36 37 ByFirstech,LLC