Firstech, LLC. Technical Data (CM3000)
Connector #2:
Pin #1: Green/White- This is the low voltage (-) parking light output 200mA. Some newer vehicles require a (-) parking light output instead of the standard (+) output (reference connector #1) such as the new Jeeps and even some Fords.
Pin #2: Black- This is the (-) Status Out wire. It provides you with a (-) 200mA output as soon as the remote start is activated. This is the sequence:
1.Remote Start unit receives signal to activate
2.At that time the Status becomes active providing the (-) 200mA trigger
3.The ignition will activate and the car will start.
This is the wire you would connect to a Transponder Module or maybe a VATS module.
Pin #3: Green- This wire is the (-) 2nd ignition 200mA output. You may connect this wire to the purple pigtail of the additional relay on CN #1. This will result in a (+) trigger output for the 2nd ignition on the blue wire of the same relay.
Pin #4: White/Black- This wire is the (-) 2nd Accessory 200mA output. You may connect this wire to the purple pigtail of the additional relay on CN #1. This will result in a (+) trigger output for the 2nd accessory on the blue wire of the same relay.
Pin #5: Red/Black- This wire is a (-) 2nd Starter 200mA output. Normally the only vehicle this would be used on Nissan’s and older Ford’s. You may connect this wire to the purple pigtail of the additional relay on CN #1. This will result in a (+) trigger output for the 2nd starter on the blue wire of the same relay.
