Firstech, LLC. Technical Data (CM3000)
Connector #1:
Pin #1: Red- This wire is used as the (+) constant power input for the unit. This wire must be connected for the unit to function correctly.
Pin #2: Green/White- This wire is the (+) positive parking light output. Connect this wire directly to the (+) trigger wire generally off the parking light switch or found at or behind the fuse box.
Pin #3: Red/White- This wire has two functions: it powers the unit, and is connected to the pre-wired relay* found on the main ignition harness. This wire has to be connected to a constant power for the unit to function correctly.
Pin #4: White- This wire is used to power the (+) accessory, which activates the blower motor for the heater or A/C.
Pin #5: Violet- This wire is the (-) negative when armed out. It will provide a (-) output anytime the unit is armed or remote started. This wire is pre-wired into the starter-kill. This wire could be used for adding a window roll-up.
Pin #6: Yellow- This wire is the (+) Starter output. This is pre-wired to the starter-kill relay for ease of installation. At the starter-kill relay you will see a yellow and yellow/black. These wires are used to interrupt the starter wire in the vehicle. You will need to cut the starter wire in half and connect the wire accordingly: Yellow/Black will connect to the key side and the yellow will connect to the motor side (starter side).
Pin #7: Green- This wire is used to power the (+) ignition. This wire is also an input for the CompuStar used to monitor the status of the vehicle and for programming.
Pin #8: Black- This wire needs to be connected to a chassis (-) ground. It is very important to make sure you have a good ground or the unit will not function correctly.
*Pre-wired relay: There is a purple pigtail and also a blue wire that is the same length as the rest of the wires in CN#1. This relay is used for adding a 2nd ign or 2nd acc or a 2nd starter in conjunction with connector #2.
