BATTERY REPLACEMENT
Two
1.To open the battery compartments, press gently down and out on the battery door latch. The doors are tethered; do not attempt to completely remove them.
2.Tilt the housing gently and the batteries will slide out.
3.Insert the new batteries. Make sure the contact end goes in first and that you match the polarity markings on the control housing.
4.To close, simply hook the lower edge of the battery door over the inside of the battery compartment and gently push shut.
Battery replacement is simple with the
Figure 10. Battery replacement
22
SETTING UP
Your new
1.Unpack your
Control | Speaker | Cable connector and | Search coil |
Housing |
| battery compartments |
|
| (on back) |
| |
|
|
| |
Control Panel |
| Search |
|
|
| cable |
|
Headphone |
|
|
|
Jack |
|
|
|
Arm rest | Hand |
| Search coil |
grip |
| ||
|
| wing nut | |
|
|
| |
|
| Upper | Lower stem |
|
| Handle |
|
|
| Spring Lock | Lock nut |
|
|
| |
|
| Velcro® straps | |
|
|
| |
|
| Stand |
|
|
|
|
|
|
|
| Figure 2. |
2.Slip the lower stem into the upper handle.
3.With the search coil cable still disconnected from the control housing, adjust the stem length and coil angle so that the search coil rests flat on the ground about 6 to 12 inches in front of and slightly to the right of your right foot (to the left of your left foot for left handers). The stem length is adjusted by loosening the lower lock nut and allowing the spring lock to snap into one of the holes in the upper handle. The coil angle is adjusted by loosening the nylon wing nut on top of the search coil.
NOTE: Your arm should be straight and relaxed with the hand grip held comfortably (not tight).
7
1236x2 | 6/9/06 10:08:57 AM |