Yamaha RX-V1700 owner manual 121 En, During Auto Setup, After Auto Setup

TROUBLESHOOTING

During AUTO SETUP

Error message	Cause	Remedy	See
			page
E-1:NO FRONT SP	Front L/R channel signals are not detected.	Check the front L/R speaker connections.	14
E-2:NO SURR.SP	A surround channel signal is not detected.	Check the surround speaker connections.	14
E-3:NO PRNS. SP	A presence channel signal is not detected.	Check the presence speaker connections.	14
E-4:SBR->SBL	Only right surround back channel signal is	Connect the surround back speaker to the
	detected.	LEFT SURROUND BACK SPEAKERS	14
		terminal if you only have one surround
		back speaker.
E-5:NOISY	Background noise is too loud.	Try running “AUTO SETUP” in a quiet	—
		environment.
		Turn off noisy electric equipment like air
		conditioners or move them away from the	—
		optimizer microphone.
E-6:CHECK SUR.	Surround back speakers are connected,	Connect surround speakers when you use	14
	though surround L/R speakers are not.	surround back speakers.
E-7:NO MIC	The optimizer microphone was unplugged	Connect the supplied optimizer microphone
	during the “AUTO SETUP” procedure.	to the OPTIMIZER MIC jack on the front	32
		panel.
E-8:NO SIGNAL	The optimizer microphone does not detect	Check the microphone setting.	32
	test tones.
		Check the speaker connections and	14
		placement.
E-9:USER CANCEL	The “AUTO SETUP” procedure was	Run “AUTO SETUP” again.	32
	cancelled due to user activity.
E-10:INTERNAL ERROR	An internal error occurred.	Run “AUTO SETUP” again.	32
After AUTO SETUP

Warning message	Cause	Remedy	See
			page
W-1:OUT OF PHASE	Speaker polarity is not correct. This	Check the speaker connections for proper
	message may appear depending on the	polarity (+ or –).	14
	speakers even when the speakers are
	connected correctly.
W-2:OVER 24m (80ft)	The distance between the speaker and the	Bring the speaker closer to the listening	—
	listening position is over 24 m.	position.
W-3:LEVEL ERROR	The difference of volume level among	Readjust the speaker installation so that all	—
	speakers is excessive.	speakers are set in locations with similar
		conditions.
		Check the speaker connections.	14
		Use speakers of similar quality.	—
		Adjust the output volume of the subwoofer.	32

INFORMATION ADDITIONAL

Notes

•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

•If warning “W-1” appears, corrections are made, but they may not be optimal.

•If warning “W-2” or “W-3” appears, no corrections are made.

•If error “E-10” occurs repeatedly, please contact a qualified YAMAHA service center.

English

121 En