
Adjusting the speaker level
You can adjust the output level of each speaker while listening to a music source. This is also possible when playing sources input at the MULTI CH INPUT jacks.
Note
This operation will override the level adjustments made in “AUTO SETUP” (see page 32) and “SP LEVEL” (see page 83).
1Set the operation mode selector to AMP and then press LEVEL on the remote control repeatedly to select the speaker you want to adjust.
AMP
LEVEL
SOURCE
TITLE
TV
Display | Adjusted speaker |
FRONT L | Front left speaker |
|
|
CENTER | Center speaker |
|
|
FRONT R | Front right speaker |
|
|
SUR. R | Surround right speaker |
|
|
SB R | Surround back right speaker |
|
|
SB L | Surround back left speaker |
|
|
SUR. L | Surround left speaker |
|
|
SWFR | Subwoofer |
|
|
PRNS L | Presence left speaker |
|
|
PRNS R | Presence right speaker |
|
|
y
•Once you press LEVEL on the remote control, you can also select the speaker by pressing k / n.
•Instead of “SB R” and “SB L”, “SUR. B” is displayed if “SB L/R SP” is set to either “SMLx1” or “LRGx1” (see page 82).
2Press l / h on the remote control to adjust the speaker output level.
•Press i to increase the value.
•Press j to decrease the value.
Control range:
PRESET/CH
ENTER
A/B/C/D/E
USING AUDIO FEATURES
Enjoying multi-channel sources in 2-channel stereo
You can mix down
1Set the operation mode to AMP and then press STEREO on the remote control repeatedly to select “2ch Stereo”.
AMP
STEREO
SOURCE
5
TV
2ch Stereo
y
•You can use a subwoofer with this program when “LFE/BASS OUT” is set to “SWFR” or “BOTH” (see page 80).
•You can also select the “2ch Stereo” mode by rotating the PROGRAM selector on the front panel.
2Press PARAMETER and then l / h to set the “DIRECT” parameter.
PRESET/CH
PARAMETER
DISPLAY
ENTER
A/B/C/D/E
Choices: AUTO, OFF
•Select “AUTO” to bypass the decoders, DSP processors and the tone control circuitry only when “BASS” and “TREBLE” are set to 0 dB (see page 50).
•Select “OFF” not to bypass the decoders, DSP processors and the tone control circuitry when “BASS” and “TREBLE” are set to 0 dB.
y
•When
•The
–“LFE/BASS OUT” is set to “BOTH” (see page 80).
–“FRONT SP” is set to “SMALL” (see page 81) and “LFE/BASS OUT” is set to “SWFR” (see page 80).
•Press PARAMETER again to exit from the parameter setting mode.
OPERATION | BASIC |
|
|
English