Yamaha RX-V1700 owner manual 90 En, Display settings Adisplay SET

CUSTOMIZING THIS UNIT (MANUAL SETUP)

4 OPTION MENU

Use this menu to adjust the optional system parameters.

4 OPTION MENU 1/2		4 OPTION MENU 2/2
. A)DISPLAY		. E)PARAM. INI
B)MEMORY GUARD		F)ZONE SET
C)AUDIO SELECT		G)DOCK
D)DECODER MODE		p
p	p		p

■Display settings A)DISPLAY SET

Note

Use “V-RESET” in “ADVANCED SETUP” to set the parameters in “DISPLAY SET” (except “DIMMER”, “SHORT MESSAGE”, “ON SCREEN” and “FL SCROLL”) to the factory presets (see page 112).

A)DISPLAY SET

.;;;;;;;;;;0 SHIFT;;;;;;;0 BACK;;;;AUTO

V;;;;;;;;ON

p p

p[

Dimmer DIMMER

Use this feature to adjust the brightness of the front panel display.

Control range: – 4 to 0

Control step: 1

•Press l to make the front panel display dimmer.

•Press h to make the front panel display brighter.

OSD shift OSD SHIFT

Use this feature to adjust the vertical position of the OSD. Control range: –5 (upward) to +5 (downward)

Control step: 1

Initial setting: 0

•Press l to raise the position of the OSD.

•Press h to lower the position of the OSD.

Gray back GRAY BACK

Use this feature to display a gray background in your video monitor when there is no video signal being input. Choices: AUTO, OFF

•Select “AUTO” to display a gray background in your video monitor when there is no video signal being input.

•Select “OFF” not to display a gray background in your video monitor.

Notes

•Depending on the video signals being input or the system setting of your video monitor (NTSC or PAL), the OSD may be displayed abnormally. In such cases, set “GRAY BACK” to “OFF”.

•Even when “GRAY BACK” is set to “OFF”, the OSD may not be displayed correctly depending on the conditions of the picture.

Video conversion V CONV.

Use this feature to set whether to convert the video signals input at the VIDEO, S VIDEO and COMPONENT VIDEO jacks.

Choices: ON, OFF

•Select “ON” to convert composite, S-video and component video signals interchangeably and up- convert composite and S-video and component video signals to HDMI video signals.

•Select “OFF” not to convert any signals.

Notes

•This unit does not convert 480 line video signals and 576 line video signals interchangeably.

•The converted video signals are only output at the MONITOR OUT jacks. When recording a video source, you must make the same type of video connections between each component.

•When composite video or S-video signals from a VCR are converted to component video signals, the picture quality may suffer depending on your VCR.

•Set “V CONV.” to “ON” to display the sound field parameter display and short message display.

•Unconventional signals input at the composite video or S-video jacks cannot be converted or may be output abnormally. In such cases, set “V CONV.” to “OFF”.

•When non-standard video signals (such as video signals from a game console) are input, this unit may not convert the signals even if you set “V CONV.” to “ON”.

90 En