Yamaha RX-V1700 owner manual 15 En, Connecting the speaker cable

Models: RX-V1700

1 140
Download 140 pages 22.1 Kb
Page 17
Image 17

FRONT terminals

Connect front left and right speakers to these terminals.

CENTER terminals

Connect a center speaker to these terminals.

SURROUND terminals

Connect surround left and right speakers to these terminals.

SURROUND BACK terminals

Connect surround back left and right speakers to these terminals.

Note

When you use a surround back speaker, connect the speaker to the left SURROUND BACK terminal (SINGLE).

PRESENCE terminals

Connect presence left and right speakers to these terminals.

SUBWOOFER jack

Connect a subwoofer with a built-in amplifier (such as the YAMAHA Active Servo Processing Subwoofer System) to this jack.

CONNECTIONS

Connecting the speaker cable

1Remove approximately 10 mm of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits.

10 mm

2Loosen the knob using the supplied speaker terminal wrench.

Speaker terminal wrench

Red: positive (+)

Black: negative (–)

3Insert one bare wire into the hole on the side of each terminal.

4Tighten the knob to secure the wire using the supplied speaker terminal wrench.

PREPARATION

English

15 En

Page 17
Image 17
Yamaha RX-V1700 owner manual 15 En, Connecting the speaker cable