
CUSTOMIZING THIS UNIT (MANUAL SETUP)
5Press k / n repeatedly and then press ENTER to select and enter the desired submenu.
The following display is an example where “LFE LEVEL” is selected.
PRESET/CH
PRESET/CH
ENTER
ENTER
A/B/C/D/E
A/B/C/D/E
B)LFE LEVEL
.;;;;;;0dB
;;;;0dB
p | p |
p[
6Press k / n to select the desired parameter and then l / h to change the parameter settings.
•Press h to increase the value.
•Press l to decrease the value.
PRESET/CH
PRESET/CH
ENTER
ENTER
A/B/C/D/E
A/B/C/D/E
7Press SET MENU to exit from “SET MENU”.
SET MENU
MENU
SRCH MODE
1 BASIC MENU
Use this menu to manually adjust any speaker settings.
2 BASIC MENU
. A)SPEAKER B)SP C)SP
D)TEST
p | p |
■ Speaker settings A)SPEAKER SET
Use this feature to manually adjust any speaker settings.
y
•If you are not satisfied with the bass sounds from your speakers, you can change these settings according to your preference.
•When the diameter of the woofer section of the speaker unit is larger than 16 cm (6.5 in), set the correspondent speaker setting parameter to “LARGE” (or “LRG”).
LFE/Bass out LFE/BASS OUT
Use this feature to select the speakers that output the LFE
LFE/BASS OUT
[
•Select “SWFR” (subwoofer) if you connected a subwoofer. The LFE signals as well as the low- frequency signals of other speakers set to “SML” (or “SMALL”) are directed to the subwoofer.
•Select “FRONT” (front) if you did not connect a subwoofer. The LFE signals, the
•Select “BOTH” (both) if you connected a subwoofer. The
page 80).