AUTO SETUP
Volume level LEVEL
Checks and adjusts the volume level of each speaker. Choices: CHECK, SKIP
•Select “CHECK” to automatically check and adjust this item.
•Select “SKIP” to skip this item and perform no adjustments.
8Press n to select “START” and then press
ENTER to start the setup procedure.
This unit starts the auto setup procedure. Loud test tones are output from each speaker during the auto setup procedure. Once all items are set, the “RESULT:EXIT” display appears in the OSD.
PRESET/CH
PRESET/CH
ENTER
ENTER
A/B/C/D/E
A/B/C/D/E
Notes
•During the auto setup procedure, do not perform any operation on this unit.
•We recommend getting out of the room while this unit is in the auto setup procedure. It takes approximately 3 minutes for this unit to complete the auto setup procedure.
The display changes as follows.
1 AUTO:MENU
;;;;;;;AUTO
;;;;;CHECK
;;;CHECK
;;;;;;;CHECK
;;;;;;;NATURAL
;;;;;;CHECK
.START
p | p |
p[
2 AUTO:CHECK
INITIALIZING
.CHECK
MAIN CHECK EQUALIZING LEVEL
CHECK CH=CENTER
;;;;;;;;
p
RESULT:EXIT
.RESULT
. SP : 5/4/0.1
.DIST: 4.50/ 6.10m
.LVL :
[SET CANCEL
p | p |
The results displayed under “RESULT” are as follows.
Number of speakers SP
Displays the number of speakers connected to this unit in the following order: Front/Back/Subwoofer
Speaker distance DIST
Displays the speaker distance from the listening position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LVL
Displays the speaker output level in the following order:
Lowest speaker output level/Highest speaker output level
Notes
•If
•If you selected “RELOAD” in step 4, no test tones are output.
•If an error occurs during the “AUTO:CHECK” procedure, the setup procedure is canceled and an error screen appears. For details, see “If an error screen appears” on page 36.
•When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” and the number of warning messages appears in the above of “RESULT” (see page 37).
•Depending on the listening environment, “SWFR PHASE:REV” appears during the “AUTO:CHECK” procedure and “SUBWOOFER PHASE” in “SOUND MENU” (see page 82) is automatically set to “REVERSE”.
