Warnings and Safety information
WARNING!
Cut Hazard
Take care - panel edges are sharp.
Failure to use caution could result in minor injury or cuts.
CAUTION!
In order to avoid hazard these products must be installed according to these instructions.
Please follow installation information carefully. If in doubt consult your local building authority
Failure to install the product correctly could invalidate any warranty or liability claims.
The product is to be connected to the electrical supply only by a suitably registered electrical person.
IMPORTANT!
Please make this information available to the person responsible for installing the product as it could reduce your installation costs.
The cavity must be a completely sealed box with no gaps. This will ensure the cooling air flows under the product and through the oven frame to give the correct venting and cooling for the oven and cabinet surround. Failure to seal the cavity box may cause distortion of surrounding cabinetry.
Read these instructions carefully before installing or using this product.
Before you start
Ensure a suitable disconnection switch is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. The switch must be of an approved type installed in the fixed wiring and provide a 3 mm air gap contact separation in all poles in accordance with the local wiring rules.
In Australia and New Zealand, a switch of the approved type with a 3 mm air gap must be installed in the active (phase) conductor of the fixed wiring.
Ensure that the location of the oven connection socket (if fitted) is outside the installation space if the product is flush to the rear wall.
Ensure the electrician provides sufficient free length of mains cable to reach from the bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening. The cable may enter the cavity from the side, top or bottom, but entry must be at the rear of the cavity.
Ensure that the benchtop and oven cavity are square and level.
Use
will help to remove any staining caused by cooking fumes.
Check that the height of the product from the floor suits the user.
Ensure that the oven door(s) will be clear of obstructions when fully opened.
3
