RIDGID Complete Guide to R5010 Hammer Drill Operation and Chuck Maintenance

Models: R5010

1 18

Page 14

The chuck must be removed in order to use some accessories. To remove:

Unplug your drill.

WARNING:

Failure to unplug your drill could result in acciden- tal starting causing serious injury.

Using two open-end wrenches, loosen the chuck. See Figure 13.

This will loosen the chuck on the spindle. It can now be unscrewed by hand.

The chuck may at times become loose on the spindle and develop a wobble. To tighten, follow these steps:

Unplug your drill.

WARNING:

Failure to unplug your drill could result in acciden- tal starting causing serious injury.

Using two open-end wrenches, tighten the chuck. See Figure 14.

This will tighten the chuck on the spindle.

Fig. 13

Fig. 14

Image 14

Contents

Operators Manual Table of Contents IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaAdditional Safety Rules Specific Safety RulesService Symbols Symbol Name DESIGNATION/EXPLANATIONDouble Insulation SpecificationsElectrical Extension CordsInstructions UnpackingApplications Packing ListFeatures Keyless Chuck OperationLOCK-ON Button Variable Speed TWO-SPEED Gear Shift KnobAdjusting the Depth Gauge ROD Follow these steps to adjust the auxiliary handle assemblyTo Install Bits To Remove BitsDrilling Helpful HintsChuck Removal To Retighten a Loose ChuckLubrication MaintenanceGeneral What is Covered Under the Limited Three Year Warranty WarrantyDAY Satisfaction Guarantee Policy HOW to Obtain Service What is not CoveredPage Customer Service Information