OPERATION

VARIABLE SPEED

See Figures 5 & 8.

Your drill has a variable speed dial designed to allow operator control of speed and torque limits. The speed and torque of your drill can be increased by turning the dial on top of the drill.

Avoid running your drill at low speeds for extended periods of time. Running at low speeds under constant usage may cause your drill to become overheated. If this occurs, cool your drill by running it without a load and at full speed.

The following guidelines may be used in determining correct speed for various applications:

￿Low speed is ideal when minimum speed and power is required. For example, starting holes without center punching, driving screws, mixing paint, and drilling in ceramics.

￿Medium speed is suitable for drilling hard metals, plastics, and laminates.

￿High speed produces best results when maximum power is required. For example, drilling in wood; soft metals such as aluminum, brass, and copper, and when using driving accessories.

WARNING:

Your drill should never be connected to power supply when you are assembling parts, making adjustments, installing or removing drill bits, clean- ing, or when not in use. Disconnecting your drill will prevent accidental starting that could cause seri- ous personal injury.

TWO-SPEED GEAR SHIFT KNOB

See Figure 6.

The hammer drill has a two-speed gear shift knob which provides a high speed of approximately 3,000 RPM and a low speed of approximately 1,000 RPM (stated speeds are with the trigger switch in “Full-On” position).

TO INCREASE SPEED, PULL SWITCH TRIGGER

Fig. 5

Fig. 6

WARNING:

Failure to unplug your drill could result in acciden- tal starting causing serious injury.

For high speed operation, rotate two-speed gear shift knob clockwise aligning with indicating mark on knob. For low speed operation, rotate knob counterclockwise with indicating mark on knob. It may be necessary to rotate the chuck by hand while rotating knob.

CAUTION:

Never change gears while the tool is running. Failure to obey this caution could result in serious damage to the drill.

WARNING:

The hammer drill should never be connected to a power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when the tool is not in use. Disconnecting the tool will prevent accidental start- ing that could cause serious injury.

10

Page 10
Image 10
RIDGID R5010 manual Variable Speed, TWO-SPEED Gear Shift Knob