11FIT CLAMPING BRACKETS BASED ON THE BENCHTOP THICKNESS
x 4
view from below
12 SECURE TO BENCHTOP | 11 |
|
40mm+ |
Repeat on all the other sides
13CONNECT TO GAS SUPPLY
14CHECK ALL CONNECTIONS FOR GAS LEAKS
NGModels
Arrow
Make sure to fit the supplied regulator.
Adjust to obtain a test point pressure of 1 kPa with all burners operating at highest setting.
LPGModels
Make sure to fit the supplied test point adaptor.
Make sure the supply pressure is regulated to 2.75 kPa, with all
burners operating at highest setting.
GAS
GAS
ONON
ALLModels
Make sure the connection point will be accessible with the cooktop installed.
To enable the gas supply to be readily shut off by the customer, make sure the connection is fitted with an isolating valve close to the cooktop.
Ifconnectingthegaswithaflexible hose:
Ensure the hose is long enough to allow for removal of cooktop for servicing. Make sure the connector is located as shown in step 5 CLEARANCE DIMENSIONS.
The hose assembly must be AS/NZS 1869 Class B or D certified, with an Rp ½” (ISO 7‐1) female thread connection. The hose assembly must be no longer than 1.2 m in length with minimum internal
diameter of 10 mm and comply with relevant AS 5601/NZS 5261 requirements. The hose must not be kinked, subjected to abrasion or permanently deformed. The hose must not be near or in contact with any hot surfaces
(e.g. base of metal hotlplate, flue, or chassis of underbench oven etc.)
