(2,1)
10LEVEL AND SECURE THE PRODUCT
Ensure product is level and |
| max. ¾” (19 mm) | 2 |
aligning with cabinetry. |
| ||
|
|
| |
Using the most appropriate | C | C |
|
length Hexagonal socket |
|
| optional |
supplied, fully extend |
|
| |
levelling feet up to required |
|
|
|
distance by hand. |
|
|
|
10SECURE THE PRODUCT
Open the upper drawer halfway. |
| Using a small Philips screwdriver, | |
Using a | 1 | ||
screw through the trim moulding, | |||
the plastic gray plug out of the trim | |||
| securing the side mounting | ||
moulding. |
| ||
| bracket to the cabinetry. Do not | ||
|
| ||
|
| damage the rubber trimseal. |
Hexagonal socket
1
BB
A 
A
The product has three pairs of mounting brackets: a pair of optional brackets on the top (C) and two pairs of formed brackets in the side of the chassis (A,B). Use at least two out of the three pairs to secure the product.
Ensure the sound insulation is repositioned
correctly.
2
4 OPTIONAL | optional |
max. ¾” (19 mm) |
x 4 | 1 |
|
3
11REFIT THE DRAWER
Replace the plastic gray plug back into the trim moulding and ensure the trimseal is facing forward.
4 | Repeat for all four brackets. |
FINALLY, FOR BOTH METHODS, FIT THE TOEKICK
| Ensure the drawer clips on |
5 | both sides are reset. |
|
4
4
Ensure the drawer is now rotated clockwise back.
1
3
Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward.
3
4 | 5 |
|
| Where the toekick |
| meets the bottom |
1 | of the tub is the |
19 
19 
2
6 | 7 |
8 | Important! |
|
| 9 | |
| Do not overtighten screw. |
2
