Front panel adjustment (Prefinished models only)
DishDrawer®
DD36SDFTX, DD90SDFTM, DD90SDF(H)TX models | US CA NZ AU GB IE |
Important!
SAVE THESE INSTRUCTIONS
The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed at the end of this document or contact your local Fisher & Paykel dealer.
If, after installation, the front panel of your DishDrawer is not correctly aligned with the front panels of surrounding cabinetry, it can be adjusted as follows.
1SAFETY AND WARNINGS
WARNING!
Electrical shock hazard
WARNING – To reduce the risk of electric shock, fire, or injury to persons, the installer must ensure that the DishDrawer® is completely enclosed at the time of installation.
Before fitting the front panel and connecting the controls, make sure that the DishDrawer® is completely enclosed by cabinetry, and disconnected from the power supply.
The controls must be electrically connected by a suitably qualified installer.
Failure to follow these warnings may result in electrical shock, injury or fire.
Important safety instructions!
Read these instructions completely and carefully. Ensure the product is not plugged in.
Installation of DishDrawer® panels requires basic mechanical and electrical skills. Installation must comply with your local building and electricity regulations.
Failure to install the Dishdrawer® panels correctly could invalidate any warranty or liability claims.
WARNING!
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.
